Mercedes-Benz Case Study · 68

Mercedes-Benz CLA180 shock absorbers, replaced.

A Mercedes-Benz CLA180 came in with poor handling, a floaty, unsettled feel. The shock absorbers were worn front and rear. Replaced as axle sets, the handling and the ride back.

Job done

Mechanical Repairs Suspension Mercedes-Benz Specialist
Mercedes-Benz CLA180 parked at the workshop, in for shock absorber inspection.

The brief

The CLA180's driver was troubled by poor handling, a vague, floaty, unsettled feel through corners and over bumps, the kind of thing that creeps in so slowly you don't notice until it's bad. He brought it in, and a check traced it to worn shock absorbers. The shock damps the spring, it stops the car carrying on bouncing after a bump and keeps the tyres pressed on the road through corners, over rough surfaces, and under braking. As the shocks wear the damping fades, so the body floats and rolls, the handling goes vague, and the tyres skip along instead of staying planted. Shocks fade gradually so you get used to it, but it's a real handling, grip and safety issue, so worn ones need changing.

The worn shock absorbers on the Mercedes-Benz CLA180, weeping and weak.

The diagnosis

On the lift each shock got a bounce-and-inspect. The fronts were past it, weak damping and weeping, and the rears had gone too, the body carrying on after a push at both ends instead of settling in one. The shocks had all done their miles. When they've gone like that, you do them as axle sets, the matching corners together, so it was the front pair and the rear pair, fresh shocks all round.

The old front struts removed alongside the new pair.

The work

Both front struts and both rear shocks were unbolted and removed, and new genuine Mercedes-spec shocks fitted front and rear, the top mounts checked and renewed as needed, every fastener torqued to the manual figures. With everything back together the front geometry was checked and set so the new shocks weren't fighting a misaligned corner. A road test confirmed the handling had sharpened, the ride had settled, the car planted again through corners and over bumps.

The new genuine Mercedes-spec front struts ready to fit.

The outcome

Sharper handling, flat through corners, a composed ride that settles in one motion, and the tyres back to wearing evenly. The CLA180 went home handling properly again. Worn shocks only get softer and they take handling, ride quality, braking and tyre life down with them, so doing the lot as axle sets reset the car rather than chasing the next worn one a few months later.

The old rear shocks removed alongside the new pair.
Got something similar?

Poor handling on your Mercedes?

If the handling's gone vague, the car floats over bumps, or it doesn't feel planted, the team can check the shocks and put it right. Drop us a message.

← Back to Mercedes-Benz case studies